Enable Huijue Core Switch Ports

To enable a port on a Huawei Core Switch, access the CLI, enter system-view, select the interface, and execute undo shutdown.

Step-by-Step Guide

1. Access the Switch CLI Connect to the switch using a console cable or SSH. Log in with your administrator credentials .
2. Enter System View Enter configuration mode by typing:

   system-view This allows you to modify interface settings .

3. Select the Target Port Navigate to the port you want to enable. For example:

   interface GigabitEthernet 0/0/1 Replace 0/0/1 with the actual port ID .

4. Enable the Port Activate the port using:

   undo shutdown This command brings the interface up .

5. Assign VLAN (Optional) For access mode:

   port link-type accessport default vlan 10 Replace 10 with your desired VLAN ID .

6. Configure Port Security (Recommended) To prevent unauthorized access:

   port-security enableport-security mac-address sticky Optionally, apply rate limiting:

   qos lr outbound cir 100000 Adjust the bandwidth value as needed .

7. Verify Configuration Check the port status and VLAN assignment:

   display interface GigabitEthernet0/0/1display vlan Ensure the port is active and correctly assigned .

8. Save Configuration Make changes permanent:

   save This prevents configuration loss after a reboot .

Security Considerations

• Use ACLs to restrict traffic to trusted IP ranges:

  acl 3000

• Avoid leaving ports open without security measures to prevent potential network vulnerabilities . Following these steps ensures that your Huijue Core Switch ports are enabled, properly configured, and secured for network operations.