How to set up a PPPoE fiber optic router

To set up a PPPoE fiber optic router, connect it to your ONT, access the router's admin panel, select PPPoE as the internet type, and enter your ISP-provided username and password.

Step 1: Connect Your Hardware

1. Plug in the router's power adapter and ensure it is powered on.
2. Make sure your Optical Network Terminal (ONT) is powered and the LED indicators are active.
3. Connect an Ethernet cable from the ONT's LAN port to the WAN port on your router.
4. Connect your computer to the router via Ethernet or Wi-Fi using the default network credentials printed on the router label .

Step 2: Access the Router Admin Panel

1. Open a web browser and enter the router's IP address (commonly 192.168.0.1 or 192.168.1.1) in the address bar .
2. Create a strong admin password with uppercase, lowercase, numbers, and special characters, then log in .

Step 3: Configure PPPoE Settings

1. Navigate to the WAN or Internet Settings section.
2. Select PPPoE as the connection type .
3. Enter the username and password provided by your ISP. Ensure the credentials are entered exactly as given, including case sensitivity .
4. Skip VLAN ID unless your ISP specifically requires it.
5. Save the settings and, if prompted, restart the router .

Step 4: Complete Quick Setup (Optional)

1. Some routers, like TP-Link Wi-Fi 6 models, offer a Quick Setup wizard.
2. Select your region and time zone, choose Router Mode, and confirm the PPPoE credentials .
3. Configure Wi-Fi settings and update firmware if necessary .

Step 5: Verify Connection

1. Check the router's status page to confirm the PPPoE connection is active.
2. Test internet access on a connected device.
3. If the connection fails, reboot both the ONT and router and recheck credentials . Following these steps ensures your fiber optic router is properly configured for PPPoE, providing a stable and secure internet connection.